Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-21-2004, 12:17 PM
|
#10 |
|
Registered Member
Join Date: Dec 1999
Location: Warrington, PA
Posts: 694
|
I think you have the right idea. The problem with the bends in the pipe is when a bend comes before the MAF. The air tends to go to one side of the MAF because of the differences in air velocities around the two different radius's of the bend....(orrr...some...thing...like.. that
 )If you are running a straight shot into the MAF with a K&N cone filter like you said, then you shouldn't have to worry about any potential losses contributed to bends in the intake system. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|