Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
01-27-2004, 11:46 PM
|
#1 |
|
Registered Member
Join Date: Jun 2003
Location: Wisconsin
Posts: 348
|
hmmm not sure if you should use it on the timing cover area where the crank seal is where it loops down. try and get that rubber piece that should slide in the cover there and use silicone for the rest. But if worst comes to worst, i guess silicone will work for it all, if its used properly. Just make sure you prep the surfaces really well(no oil, grease, debris, etc).
__________________
92 Mustang GT, 347 Stroker(Forged Steel Crank/Rods-Balanced, Forged Aluminum Dished Pistons), Trick Flow Track Heat Intake, Trick Flow Twisted Wedge Heads w/ Stage 3 port/polish, 80mm C&L MAF, FMS 30# Inj., BBK AFPR, Trick Flow Stage 2 Cam, Trick Flow 1.6R Rockers, BBK E.L. Headers, Flowmaster Cat-Back, MAC CAI, FMS Pulleys, Griffin Alum. Radiator, MSD Pro-Billet Distributor; AOD, Dynamic 3300 Lockup Converter, B & M Super Cooler, B&M Ratchet Shifter; 3:73 gears. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|