can anyone identify these codes?

PrplMonster · 08-20-2001, 08:59 AM

ok guys. Early this morning i reset the computer. You were right chris.... When i took off the Valve cover-to-TB breather tube, it set off a code 66, as far as the push or pull factor, at idle it's got vacuum. I did both the KOEO and the KOER. heres what i got.

with the KOEO:
33- EGR(no smog equip on the car, no vac to the valve)
85- Evap Canister
The Evap Canister was off when i bought it, and the hose just vents to the atmosphere. Is it ok being like that..?

with the KOER:
41- Heated lean 02 right
91- Heated lean 02 left
33- EGR again

I have fuel press set at 60psi with the vac. off.. how could i be lean like that?

Also: This only happens when moving foward/reverse, my idle will hover for a second or two around 1300-1500 then return to idle. Remember, this only happens when moving.

About the lean condition, the MAF meter says 24 right on it. I know i am getting a good spray from the nozzle. What gives..?

thanx for all your help guys(jimberg/PckrWud)
.dave

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
O2 codes at open loop?	Nixon1	Windsor Power	6	04-24-2004 08:43 PM
KOEO & continuous memory codes??	Simi Stang	Windsor Power	4	12-16-2003 02:37 PM
Codes	86GT	Windsor Power	6	07-30-2002 07:44 PM
Help with codes?	withamc	Windsor Power	1	06-17-2001 10:22 PM
No Computer Codes = Bad Parts? (long)	slo95	Windsor Power	6	04-03-2001 09:03 PM

08-20-2001, 08:59 AM	#1
PrplMonster Registered Member Join Date: Mar 1999 Posts: 88	ok guys. Early this morning i reset the computer. You were right chris.... When i took off the Valve cover-to-TB breather tube, it set off a code 66, as far as the push or pull factor, at idle it's got vacuum. I did both the KOEO and the KOER. heres what i got. with the KOEO: 33- EGR(no smog equip on the car, no vac to the valve) 85- Evap Canister The Evap Canister was off when i bought it, and the hose just vents to the atmosphere. Is it ok being like that..? with the KOER: 41- Heated lean 02 right 91- Heated lean 02 left 33- EGR again I have fuel press set at 60psi with the vac. off.. how could i be lean like that? Also: This only happens when moving foward/reverse, my idle will hover for a second or two around 1300-1500 then return to idle. Remember, this only happens when moving. About the lean condition, the MAF meter says 24 right on it. I know i am getting a good spray from the nozzle. What gives..? thanx for all your help guys(jimberg/PckrWud) .dave