Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
02-15-2004, 10:56 PM
|
#1 |
|
Registered Member
Join Date: Apr 1999
Location: St.Louis,MO
Posts: 274
|
On the A9l series it is pin 22. '94 - '95 is also pin 22. I'll go out on a limb and say it is probably the same on '86. Some things they haven't changed over the years.
Also, when the key is on there should be +12V to the shutting coil. So there should be two pins in the relay plug with power. See if you can jumper the grounded side(ecu side) of the shut coil and see if the pump runs. On the car that had the pump circuit fail on the ecu, we wired a manual switch (with the owners permission). Mike
__________________
Live near St.Louis? Check out Mustang Muscle and Dyno in High Ridge, MO |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gauges...mechanical or electrical? | Fox Hound | Windsor Power | 10 | 09-17-2002 04:47 PM |
| An Electrical Problem 1990 LX | MadWolf | Small Ponies | 0 | 08-21-2002 11:22 PM |
| Electrical Surge/Drop | viper5150 | Windsor Power | 2 | 08-29-2001 02:16 AM |
| electrical problems | blk88lx | Windsor Power | 2 | 06-11-2001 11:39 AM |
| Gauges!! -- Mechanical or Electrical ? | Red514LX | Windsor Power | 5 | 04-11-2001 09:08 AM |