Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
02-19-2004, 08:14 PM
|
#1 |
|
Registered Member
Join Date: Jul 2000
Location: Norman, Oklahoma, USA
Posts: 597
|
Man, that thing looks horrible! What did you do to make it look that bad? I have never seen a gasket looking so crappy. Get a new set, clean up the surface of the head really good with steal wool (cover the lifter valley with a big rag so you don't get any **** in your motor) put a new gasket on it (do both sides man!!) and drive it! Goodluck
__________________
Michael Black QuantumMotorsports Norman, OK 1984 LX Hatch 306 w/ TRW forged flat toppers, Comp Cams Magnum 292H, GT40P heads w/ 3 angle valve job, .550 lift springs, Angus Racing Roller Rockers, Weiand Stealth Intake, Holley 4150 650cfm carb, MAC 1 5/8 Long Tubes, Single Chamber Flowmasters, 91' T5 w/ Pro 5.0 shifter, Turbo Coupe 8.8 Rear w/ 3.55 gears, QA1 Motorsports tubular K member, no interior except steering wheel and seat. Coming soon: 6 or 8 point cage, Fuel Cell, Weld Draglites |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LOWER INTAKE GASKET | red90lx | Windsor Power | 0 | 03-20-2001 11:30 AM |
| OIL IN INTAKE almost sure from 'pcv' | QUIN | Windsor Power | 8 | 03-09-2001 01:58 PM |
| Fel-Pro 1250 gasket match to E7 intake ports ??? | cojonepony | Windsor Power | 1 | 01-31-2001 04:57 AM |
| New MAC intake? | gt93mustang | Windsor Power | 19 | 01-22-2001 03:33 PM |
| does gt40 intake work with sn95? | daz95gt | Windsor Power | 8 | 01-13-2001 08:20 AM |