Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-24-2001, 12:24 PM
|
#2 |
|
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
Yes they come prepacked...it never hurts to check them though if you have wheel bearing grease around. Make sure you clean the spindle really good and get all the dirt out replace the oil seals, which you probably have already planned on anyway.
 Brakes are fun aren't they------------------ Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension, SPEC stage III clutch, Lakewood SFI bell, S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon! <B |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear Wheel Bearings | Kisner | Classic Mustangs | 3 | 03-25-2004 06:14 PM |
| 1988 5.0 rear wheel bearings | davey_fl | Windsor Power | 8 | 09-25-2003 09:02 PM |
| What would make wheel bearings wear premature? | twilightcall | Windsor Power | 3 | 09-08-2003 07:25 PM |
| Front bearings ???'s | Slopok Moe | Windsor Power | 1 | 09-01-2001 01:35 PM |
| Eibach drag lauch kit has front wheel sitting higher in the front - please help | Stang_ROTY | Windsor Power | 9 | 09-01-2001 12:59 AM |