Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-24-2001, 12:35 PM
|
#4 |
|
Registered Member
Join Date: Apr 2000
Location: New Jersey
Posts: 167
|
I read on another post to torque the retaining nut (or whatever its called) to properly seat the bearing, then back it off. What is the recommended torque spec. and how much do you back it off. Thank you for your help.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear Wheel Bearings | Kisner | Classic Mustangs | 3 | 03-25-2004 06:14 PM |
| 1988 5.0 rear wheel bearings | davey_fl | Windsor Power | 8 | 09-25-2003 09:02 PM |
| What would make wheel bearings wear premature? | twilightcall | Windsor Power | 3 | 09-08-2003 07:25 PM |
| Front bearings ???'s | Slopok Moe | Windsor Power | 1 | 09-01-2001 01:35 PM |
| Eibach drag lauch kit has front wheel sitting higher in the front - please help | Stang_ROTY | Windsor Power | 9 | 09-01-2001 12:59 AM |