
© Copyright 2026 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
#12 | |
|
Rebel Fleet Commander
Join Date: Oct 2001
Location: Huber Heights, OH
Posts: 1,003
|
Quote:
)The ground is run on the outside, along the fuel lines, just drilled a small hole with a gromment. Nope, no messing with the alt wiring, unless you want to do a 130 amp upgrade Like I said, If you run your new wires back to where they were when the battery was up front, you can not go wrong.
__________________
1993 Mustang GT, PTK w/ T-64 - My Cardomain Webpage 11.25@123.5 on only 8 psi. 10.84@121 on only 1 headgasket ![]() ![]() ![]() "The Truth is, Your the Weak, and I am the Tyranny of Evil Men!"
|
|
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Battery..Solenoid..Starter problem | abesmith69 | Windsor Power | 6 | 04-09-2003 09:39 AM |
| Battery Disconnect and ECM Reset | mimicons | Windsor Power | 1 | 02-18-2003 11:20 AM |
| Battery is dead after pulley install?!? | Stang_Crazy | Windsor Power | 16 | 02-07-2002 09:39 PM |
| Battery not charging | Mustang_289 | Windsor Power | 8 | 01-04-2002 07:07 AM |
| battery removal | 82 GT | Windsor Power | 2 | 03-18-2001 04:40 PM |
