MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Reload this Page Question on Stock Temp sensor?
Register FAQ Members List Calendar Mark Forums Read

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 08-24-2001, 07:29 AM   #7
RED92LX50
Registered Member
 
RED92LX50's Avatar
 
Join Date: Aug 1999
Location: Fairfax, VA
Posts: 220
Question
I am still confused about this issue - I am installing an AutoMeter Mechanical Temp Gauge, and I was going to just remove the existing Electrical sensor & wire (stock)...will this affect the computer or anything else??? Is there another place on the block/intake where I should put the mechanical probe - and leave the stock one in place??? PLEASE LET KNOW, I am planning to finish this job tonight - Thanks!
RED92LX50 is offline   Reply With Quote
 

« Previous Thread | Next Thread »

Thread Tools
Display Modes Rate This Thread
Threaded Mode Threaded Mode
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Stock '92 E7 heads question Falcons Talon Windsor Power 2 05-26-2003 02:24 PM
Stock MAF meter question. Falcons Talon Windsor Power 3 04-28-2003 01:05 PM
Best place to put the oil temp sensor??? jpumpkinn Windsor Power 3 01-14-2002 10:19 AM
Temp sensor question RB92GT Windsor Power 2 06-23-2001 12:23 PM
Trophy Stock suspension Question? RL Wiltshire Racer's Club House 1 10-22-1999 08:21 AM


All times are GMT -5. The time now is 03:10 PM.

Archive - Top

SEARCH