Just an FYI on AutoMeter Mechanical Water Temp Gauge Install

[ByrdPE]

Originally posted by RED92LX50:
Maybe a dumb question...why would you want to retain the stock gauge(s)? I have replaced all 4 of the side factory gauges - and covered those areas with black plastic. It didn't make much sense to me to keep the electrical factory gauges in addition to more accurate mechanical ones.

No dead gauges and no black plastic.



------------------
FMS 373,Mac U/D Pullies,B&M shift kit,B&M Trans cooler,
KYB's,FMS 65mm T/B,Moroso cold air kit,75mm Bullet,BBK sub frame connectors,Power-slotted rotors w/performance friction pads
PST performance sway-bar kit,3G alternator,Maximum Motorsports Strut tower brace,Maximum Motorsports G-Load brace
Maximum Motorsports lower control arms,Autometer,oil,H2O,
volt MSD6AL,MSD Blaster coil,'Tiny Avenger'intake pipe