Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-18-2004, 02:20 PM
|
#2 |
|
Registered Member
Join Date: May 2001
Location: westerville, OH USA
Posts: 618
|
Did you grease the bearing and is the bearing retainer shaft (whatever it's called, the tubular surface the bearing rides on) in good condition? Maybe see if you can get a different brand bearing somewhere else????
__________________
1990 Notchback: BBK Ceramic Coated Full length headers, Dr. Gas 3"- 2 1/2" x-pipe, Flowmaster 40's/turndowns. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| clutch and throwout bearing questions | bmxmon | Classic Mustangs | 0 | 05-23-2004 04:32 PM |
| T5 throwout bearing chirp..Argh | squid | Windsor Power | 1 | 09-20-2002 08:37 PM |
| Need advice on throwout bearing | RPM427 | Windsor Power | 2 | 08-28-2002 02:05 PM |
| throwout bearing noise!! | Coupe5oh | Windsor Power | 1 | 04-30-2002 05:38 PM |
| is it the throwout bearing? | stanger8172 | Windsor Power | 3 | 07-22-2001 09:06 AM |