Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-21-2004, 06:50 PM
|
#2 |
|
Registered Member
Join Date: Mar 2003
Location: Wichita, KS
Posts: 53
|
You can use 85-91 Mark VII rotors if you have a 87-93 5.0 Mustang. Pre 87 5.0s, which had puny 10" rotors, would need to have their spindles upgraded to the later model. Check out http://www.svo73mm.cjb.net./ it should answer all of your questions about your options for swapping to five-lugs. Note your limited wheel options with the Mark VII rotors.
__________________
Most recent project: installed new HD T-5 w/Pro 5.0 Shifter, LUK Clutch, Prothane Engine and Trans mounts. Currently breaking in clutch. Next: complete tune-up |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 95GT Front Rotors | pepprdog | Stang Stories | 0 | 01-15-2002 11:58 AM |
| Cross Drilled Rotors - Who uses them? | 2FastLX | Windsor Power | 6 | 09-29-2001 12:05 AM |
| Brake Rotors | 93GTDIN | Windsor Power | 6 | 09-06-2001 08:55 AM |
| Update on my scraping rotors | RMARIANI | Windsor Power | 0 | 09-05-2001 09:28 AM |
| Drilled front rotors | Danielz9 | Corner Carvers Delight | 3 | 06-14-2000 01:00 AM |