Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
09-01-2001, 03:00 PM
|
#1 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
Honestly, if you want a roller setup, why not just buy a 1985-1995, 1987-1992 for forged pistons, from a junkyard?
I know where there is an 88GT engine sitting for $200 within 5mi of here. That's cheap, you get the whole engine, which should still be very good, and it won't cost too much. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Solid Roller ? | STROKER BILLY | Windsor Power | 5 | 11-19-2002 12:04 AM |
| 351W roller conversion | Capri306 | Windsor Power | 4 | 02-14-2002 04:49 PM |
| Crane roller conversion kit - Who's using it and what cam are you running? | 2FastLX | Windsor Power | 9 | 12-14-2001 04:09 PM |
| Non-Roller to Roller Block Conversion | Todd_A | Windsor Power | 1 | 06-01-2001 11:01 AM |
| Roller Bearing Idler Arm Conversion | Dinosaw | Classic Mustangs | 0 | 06-11-2000 07:12 PM |