Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
09-02-2001, 02:59 PM
|
#1 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
That combo would make more than 600hp if everything was tuned right. You'd burn the pistons, shoot the rods through the side of the block, break the crank, and if the miracle of the rotating assembly holding together did happen, you'd crack the main webbing on the block and grenade the entire engine.
Other than that, I'd step up to 42lb/hr injectors, alumininum driveshaft, drag struts and shocks, you'll need the biggest slicks you can fit, a full roll cage, C-clip eliminators, an upgraded positraction unit, rear end girdle, drag springs, and a bunch of other stuff. Nice to dream though!  |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help In Getting The Most Hp From My Current Setup | 89FHPLX | Windsor Power | 7 | 08-19-2002 04:13 PM |
| Should I Run a Carb or EFI Setup? Please Help | BlackFireN2O | Windsor Power | 1 | 08-07-2002 03:16 PM |
| drag setup?? 86GT-struts,? | 429mustang | Windsor Power | 2 | 06-20-2002 01:56 PM |
| speed density setup, could this work? has anyone tried? | mikos chris | Windsor Power | 2 | 10-13-2001 02:20 AM |
| Pics of my setup | 84_GT350 | Windsor Power | 3 | 08-18-2001 02:43 PM |