Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-28-2004, 09:05 PM
|
#10 |
|
Registered Member
Join Date: Jul 2004
Location: garden city, michigan
Posts: 4
|
i gained 12 horse with a 4 hole one
i gained 12 horse on the motor dyno with a 4 hole super sucker. there have been gains higherm dominator car guys have gained as much as 47 horse, there is an article on their page.
http://www.cfm-tech.com/HVHdominator...dynotest-1.htm http://www.cfm-tech.com/catalog/_ss4...rbs_769168.htm thats the one i have, every combo is different so every one gains diffrent #'s http://www.cfm-tech.com/catalog/_ss4...rbs_769168.htm there it is agin, i tried and it didnt come up when i hit the link. its a 4 hole 1 inch aluminum spacer. they also work with NX express and make their nitrous plates
__________________
510 horse cast iron headed 306(flywheel horsepower) http://www.prestage.com/member+pages/859.aspx http://members.cardomain.com/306er |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| crank shaft spacers | BilLster | Windsor Power | 0 | 04-24-2003 02:53 PM |
| Axle from 4 banger work? | 90LxDroptop | Windsor Power | 1 | 04-01-2002 08:54 PM |
| will a 91 mass air harness work in a 88 gt? | bryan88gt | Windsor Power | 5 | 03-24-2002 12:39 AM |
| will this work for forced induction? | mikos chris | Windsor Power | 0 | 01-14-2001 03:05 PM |
| Need some professional advice - head work, valve springs, rockers, cam. pretty long. | AxemanZZ | Windsor Power | 15 | 01-11-2001 01:30 PM |