broke door handle

[Ieatcamaros]

It must be the stock black plastic one. This is an easy job, really. From the inside of the door, remove the plastic around the latch (one screw). Remove the screw holding the window controls and door lock controls. There are two bolts holding the armrest in place. I think it takes a 10mm socket but not sure. Then, you can remove the whole door panel. Pry with a screwdriver all around the edges (mostly the latch side and the bottom) to remove the christmas tree fasteners from the door. You should be able to pull the door panel away from the door itself on the sides and at the bottom. Then you can pull straight up on the door panel to separate it from the door. You will have to fish your window controls out of its pocket too. Look to where the outside latch is (inside the door). If it has never been replaced, it is riveted in place. You have to drill those out. Get some 1/4-20 bolts and nuts to replace with. Or you can get some rivets if you had rather have them. Personally, I hate rivets for this job. Once, you get the rivets drilled out, you should be able to take the door handle out. There is a tab with a plastic bushing where the rod attaches to the handle. This is most likely what broke. Look inside the door, near where the handle was. There is a rod that sticks up and probably has the other part of your door handle on it. Pull the old tab off of the rod. Now with your new handle, insert the rod into the tab and then reinstall the handle and then your door panel. Go to Autozone and get your door handle, it is like $10 -$15 for the chrome one. You can get black if you want, but it will only break again. This is a 30 minute job with everything you need to install it. But it is a 2 hour job the first time. I am sure I left something out, but that is the most of it.

I assume this is your 88GT?

One more thing, if you get the "HELP" door handle in chrome, it comes with bolts. If my memory serves correctly.