Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
08-10-2004, 06:49 PM
|
#1 |
|
Registered Member
Join Date: Mar 2004
Location: Long Island
Posts: 58
|
i took the head off and the there is a hole in my exhuast valve. the piston looks pretty good. im going to get new heads today. im thinkin about the edel Rpm Performer heads w/2.02 intake valves ? how good are these heads over my gt40-p's ?
__________________
1990 Mustang GT Engine- 308 (bored .40 over) Probe Forged pistons (10.5:1), Scat forged crank and rods, w/Main Girdle, AFR 185 heads, GT-40 intake, CSI electric water pump. AC delete kit, No smog pump, Manual rack and pinion steering. Ignition- MSD 6AL, MSD Blaster coil, MSD hellicore wires. Drive Train- Tremic 3550, Alum. Drive shaft, 3:73 gears, Stock carrier and axels. 26X11.5 M/T Et streets. Power adder- 175 shot of laughing gas. Best ET 11.5 @120mph on squeeze, 12.4 @109mph on muscle (on gt40 heads) on the 185 heads ... ??? tba |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Track conditions | Eric4Nitrous | Windsor Power | 12 | 11-22-2002 10:59 PM |
| Annoying things at the track...Top five list | Dark_5.0 | Blue Oval Lounge | 10 | 10-11-2001 07:33 AM |
| Mustang Club of Central Iowa Autocross - May 6 - Marshalltown Go-Kart Track | KB1991 | Ford Show & Go | 0 | 05-03-2001 12:33 PM |
| Mustang Club of Central Iowa Autocross - May 6 - Marshalltown Go-Kart Track | KB1991 | Corner Carvers Delight | 0 | 05-03-2001 12:32 PM |