

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
I need 110mph Trap Speed!
Join Date: Feb 1999
Location: So, CA
Posts: 4,315
|
![]() Tire size has a small effect on gear ratio. Gear ratio isnt the problem here. HP production is. GET a good intake. Get rid of any bents infront of the maf, and put a K&N air filter right on the end of it. yes it pulls some hot air, but bends in front of the maf can screw things up. DITCH THE CHIP. Get to somewhere that can set your timing properly, it shouldnt be that hard.
I have a 4.6L motor, smog legal, stock heads/cams, and Im confident it runs very very low 12's. Skyler
__________________
2001 BMW M3 6spd 12.79@108 RIP ---- 1993 Notch w/ 98 4V 4.6 Fasttt... -1989 Saleen Mustang #406- 12.32@109 -1999 Black Cobra Coupe- JBA Shorties, Bassani Cat-X, Magnaflow 3", Pulleys, 85mm Pro-M, Ported Intake, Soild Rear w/ 4.30s, Tubular Front End, X2C arms, 13lb batt, few others. |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
New best ET-Slip attached | Stang_ROTY | Stang Stories | 22 | 10-14-2002 08:25 AM |
Do i need that thing attached to the differetial? | Coupe5oh | Windsor Power | 7 | 04-09-2002 10:24 AM |
1/4 timeslip :( What can I do??? | Sonics2042 | Windsor Power | 4 | 09-25-2001 07:51 AM |
Back from the track with a 14 sec timeslip | QuantumMotorsports | Windsor Power | 4 | 02-26-2001 11:34 AM |