Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-06-2001, 12:09 PM
|
#5 |
|
Registered Member
Join Date: Aug 2001
Location: Hoffman Estates, IL
Posts: 14
|
My rebuild trans will grind slightly into reverse. This is pretty normal. Try shifting into 5th (with the clutch in obviously) and then into reverse. This usually helps avoid the grind. Otherwise sounds like your clutch isn't releasing completely. Possibly a bad quadrant, clutch cable, release arm or the clutch is worn. Start small and eliminate the cheaper fix before dropping the trans. If they do drop it for clutch work might not be a bad time to have the trans looked at too. Otherwise you end up paying twice to look at the trans later.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Loud "pop" after clutch install, won't go into gear.. | Chris_H | Windsor Power | 3 | 08-11-2003 06:24 PM |
| T-5 swap & cable clutch problem | LuvMyStang | Classic Mustangs | 0 | 03-19-2003 08:47 AM |
| '65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
| Clutch Problems | blue302 | Windsor Power | 3 | 09-10-2001 01:37 PM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |