Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-01-2004, 01:44 PM
|
#2 |
|
Registered Member
Join Date: Aug 2002
Location: Rochester
Posts: 553
|
You will have to remove the crack pully and balancer to remove the front cover. If its leaking there, make sure you remove the pulley and balancer and clean the cover surfaces and block surfaces well and get a good set of gaskets and use RTV sealant along with the gaskets.. No more leak
 <marquee> NO MORE LEAK NO MORE LEAK </marquee> |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Major Problem During Water Pump Install | Evil Joe | Windsor Power | 27 | 07-10-2003 03:45 AM |
| Water pump install... | Bad89stang | Windsor Power | 3 | 01-19-2003 10:59 AM |
| STEWART Water Pump issues :( ?? | LOBE_50 | Windsor Power | 6 | 05-15-2002 08:34 AM |
| Water pump....AC Bracket problem | Jimmy Page | Classic Mustangs | 3 | 07-28-2001 01:54 PM |
| Pulleys, water pump, and fan clutch | dinomite | Windsor Power | 5 | 05-26-2001 09:00 AM |