

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#13 |
Registered Member
Join Date: Jul 2000
Location: San Jose CA
Posts: 149
|
![]() 93sv
You might want to consider this. A really nice fuel pressure gage is about $40 and a code scanner is about $30. It would be a taste over $70 for two tools that will allow you to perform a diagnostic test on your car that is CLOSE to what you get when they put your car up on a scope. I wont tell you it's the same, because the scope is a serious piece of instrumentation equipment. But for many day in day out general problems with a 5.0, these tools I recommend to you are invaluable. Add a simple ohm meter to the mix and you are set. These items will allow you to "communicate" with your vehicle and are essential for troubleshooting. They are not difficult to learn to use either. Just something to consider to help you take control of your vehicles maintainence and avoid costly shop labor rates. Good Luck, Dan |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Check Coolant light on when cold | Tecknowolf | Windsor Power | 2 | 09-14-2003 06:35 PM |
cold air intake | TRipSOber | Modular Madness | 13 | 05-01-2003 03:49 PM |
Cold cold air induction!!!!!! | 01 BLACK GT | Modular Madness | 3 | 07-18-2001 02:10 PM |
I cannot believe I forgot to ask about Cold Air intakes. | SlowStang2 | Windsor Power | 1 | 07-16-2001 06:26 PM |
cold air kit | DemonGT | Windsor Power | 4 | 03-17-2001 11:56 PM |