Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-26-2001, 12:06 AM
|
#16 |
|
I need 110mph Trap Speed!
Join Date: Feb 1999
Location: So, CA
Posts: 4,315
|
I wish I woulda seen your post earlier. This is obviously a MAF problem. I am running the same maf as you are with 24lb injectors. I had a similar problem after a ram air kit install. The MAF is kind of finicy of how it gets hit with the air. I dont know why... YOu could play with it a little. Also make sure its hooked up right and all, and possibly is it set for 19's? Well even a 70mm MAF isnt bad.
Skyler ------------------ -1989 Saleen Mustang #406- TFS Heads, Edelbrock intake, E-303, 3.73's, 1 5/8 shortys, Offroad-H, 2chamber flows, 36psi FPR, 15degrees timing, 70mm tb, 73mm maf, 24lb inj, Crank pulley, MSD6A, Alum driveshaft. Added: B&M Ripper, Subframes, & Turndowns. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Check Coolant light on when cold | Tecknowolf | Windsor Power | 2 | 09-14-2003 06:35 PM |
| cold air intake | TRipSOber | Modular Madness | 13 | 05-01-2003 03:49 PM |
| Cold cold air induction!!!!!! | 01 BLACK GT | Modular Madness | 3 | 07-18-2001 02:10 PM |
| I cannot believe I forgot to ask about Cold Air intakes. | SlowStang2 | Windsor Power | 1 | 07-16-2001 06:26 PM |
| cold air kit | DemonGT | Windsor Power | 4 | 03-17-2001 11:56 PM |