Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-30-2004, 09:08 PM
|
#2 |
|
Factoy Five Roadster
Join Date: May 2000
Location: Sevier Co,Tennessee
Posts: 1,681
|
Re: engine building questions
Top .015 bottom & oil .012 use a ring trimmer ONLY. Measurement is ring inside of bore, not on piston. Do each cylinder separate and do not mix rings up.
Pin on cam is what the turns the gear. Dots go as close as possible together, cam dot toward the bottom, crank is at the top.
__________________
Frank |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Classic Mustangs | 8 | 06-16-2005 11:43 AM |
| Just got a 98, have some questions? | 98GTNewbie | Modular Madness | 5 | 08-30-2003 12:41 AM |
| raced a Supra Twin Turbo | Stang35th | Stang Stories | 63 | 08-23-2003 12:36 AM |
| Desk top dyno 2000,any body ever"check" with real dyno pull after building engine? | robertwigton | Windsor Power | 8 | 12-01-2001 03:03 PM |
| Engine swap: | boeing727 | Built Ford Tough | 1 | 11-20-2001 10:38 PM |