Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-10-2001, 01:34 PM
|
#3 |
|
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
Are you sure that TOB is installed correctly? I was thinking if it is put on the fork wrong maybe, just maybe that is the issue. I don't know if the car would even shift if the bearing was put on wrong though.
Can you look into the bell and see the postiuon of the TOB, it should not be putting any pressure on the fingers while it is just sitting there. The BBK unit is the same as many aftermarket unit so I don't believe that is the issues, make sure the cable is routed down to the bellhousing correctly and it isn't going around any hard bent causing it to bind up. I don't think this is a tranny issue. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CLUTCH PROBLEMS (Fork??) | drewmp28 | Windsor Power | 6 | 07-18-2004 11:51 PM |
| Clutch Problems.... | Vishnoff | Classic Mustangs | 0 | 10-05-2002 04:47 PM |
| '65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
| '65 Mustang - Pull Away Problems | geordie | Classic Mustangs | 6 | 05-11-2002 04:46 PM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |