MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Reload this Page Need help quick!!! Rear main seal install....
Register FAQ Members List Calendar Mark Forums Read

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 01-25-2001, 03:57 PM   #3
NOS_Notch
Registered Member
 
Join Date: Sep 2000
Location: Fresno,CA. USA
Posts: 384
Post
I'm not sure if i follow you but when i did mine i just popped it in.
i put the old one over it and tapped it w/ a mallet.
Look good at the old one b4 you yank it out.



------------------
4.10's,long tubes & 75 shot...Goes 12.50's
Check it out at http://www.burnouts.webprovider.com
NOS_Notch is offline   Reply With Quote
 

« Previous Thread | Next Thread »

Thread Tools
Display Modes Rate This Thread
Threaded Mode Threaded Mode
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Need quick reply.... C/C plate install DZEE'S LX Windsor Power 1 04-06-2002 08:54 PM
Help! Quick question about rear end Niks90coupe Windsor Power 3 09-16-2001 12:43 AM
Any tips on rear assembly/lower cntrl arm install? LOCASH Windsor Power 1 04-30-2001 04:35 AM
Rear main seal ....(semi-long) Shotgun28 Windsor Power 1 03-13-2001 02:04 PM
9inch rear end install glxstang Windsor Power 3 02-05-2001 10:24 AM


All times are GMT -5. The time now is 09:27 AM.

Archive - Top

SEARCH