Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-10-2001, 01:16 PM
|
#4 |
|
Registered Member
Join Date: Aug 2001
Location: Palm Beach Gardens, Florida, USA
Posts: 191
|
Pulleys are definately a great bang for the buck mod. You can't beat anything that will give you a few HP for less than a hundred bucks.
Subframe connectors are also worthwhile. Get ones that weld in-not the bolt in type. Any subframe car will benefit in handling and in getting the power to the ground with a stiffer chassis with subframe connectors. ------------------ Todd 1995 GT/T-5 Pulleys; 65 mm TB; Flowmaster cat-back; Mac off road H-pipe; FMS aluminum driveshaft; short-throw shifter; HD clutch; Cobra R's; Cobra front and wing |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Street racing a felony.. | crewzin | Stang Stories | 2 | 03-29-2002 08:12 PM |
| Street Races Last Night | Skyman | Stang Stories | 14 | 03-19-2002 09:27 PM |
| street suspension | fastinturns | Corner Carvers Delight | 5 | 12-14-2001 08:59 PM |
| NEED ADVISE ON 4.10'S WITH STREET TIRES? | joey50gt | Windsor Power | 5 | 04-29-2001 10:58 PM |
| Street Prepared? | 1989GT | Corner Carvers Delight | 3 | 09-06-2000 02:50 PM |