Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-11-2005, 09:02 PM
|
#4 |
|
Registered Member
Join Date: Nov 1998
Location: Houston, Tx.
Posts: 3,887
|
Re: Need Mach1 Modification Advice, Please!
Your RPM's@70 = your present RPM's@70 X 410/355. And that's about right for the et as mentioned. I often run only about 13.50 et depending on track/atmospheric conditions. When I ran against an 03 Mach I, the only reason I beat him was because he had a bad RT. Otherwise, I think we would have been near even. Got him by about 3 car lengths in the 1/4 mile. He was what we call "asleep at the wheel" at the starting line, LOL. Otherwise the Mach I would have been door handle/door handle with me.
Rev
__________________
'66 Coupe, 306, 350-375 HP, C-4, 13.07 e.t., 104.8 mph, 1/4 mi. O.B.C. #2 '66 coupe |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| eibach advice needed | mustardjohn | Small Ponies | 6 | 08-19-2012 08:12 PM |
| Advice on injectors...PKRWUD I'd like your advice on this one as well | silver_pilate | Windsor Power | 3 | 06-09-2003 08:59 AM |
| Crazy Fri... mach1 vs. 66 coupe...COPS! | 66 Racer | Stang Stories | 6 | 09-30-2001 09:02 PM |
| Bolt on Performance Advice | aurilius_maximus | Modular Madness | 4 | 10-29-2000 11:23 AM |