Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-12-2001, 02:10 AM
|
#2 |
|
Registered Member
Join Date: Sep 2001
Location: frisco tx, usa
Posts: 11
|
you didnt mention which heads were on the motor, and also, which type of rocker, pedestal or stud. if they are pedestal, tighten them till the pushrod no longer twists between your fingers and stop. if stud, do the same, but then go one half turn additional and lock down. starting fuel pressure should be about 40 psi at the highest, and go from there.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|