Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-28-2005, 05:12 PM
|
#3 |
|
Registered Member
Join Date: Nov 1998
Location: Houston, Tx.
Posts: 3,887
|
Re: elec. ignition
The slip on connectors go either to the temp sending unit or the oil pressure sending unit. Which one does not register?
As for the electronic ignition, I recommend whole heartedly the MSD components. Get the magnetic sensing distributor with the MSD 6-AL ignition box. Also get the MSD recommended coil. DO NOT EVEN CONSIDER the Mallory components. I've used these and am replacing them with MSD as they fail over and over again. Rev
__________________
'66 Coupe, 306, 350-375 HP, C-4, 13.07 e.t., 104.8 mph, 1/4 mi. O.B.C. #2 '66 coupe |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ignition circuit problems | Justin 66GT | Classic Mustangs | 0 | 01-05-2005 11:37 AM |
| ignition switch gremlins ( long post? bear with me) | Marc91gt | Windsor Power | 1 | 09-04-2003 09:05 PM |
| Ignition upgrade | Mustang Cain | Windsor Power | 18 | 04-22-2002 06:16 PM |
| Ignition Problems with '87 5.0. HELP!!! | Holly | Windsor Power | 12 | 03-17-2002 05:53 PM |
| Ignition frabrication...needs some ideas | 1989_351W | Windsor Power | 0 | 08-11-2001 04:52 PM |