Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-10-2001, 04:26 PM
|
#17 |
|
Registered Member
Join Date: Jul 2001
Location: Moses Lake, Wa USA
Posts: 72
|
PKRWUD, I ran the KOEO codes and got 1st=66
2nd=66. 66= VAF/ Mass Air Flow Fault, Below minimum voltage. When i ran the KOER test i got back no codes. But i did get the 4 beeps at the beginning and later 1 1 1 11. Could ihave done it wrong? THe car idled and would later speed up idle down speed up. I also tried disconnecting the MAF at idle it did run hard but seemed to smooth out at WOT. What symptons should i have experianced. I didnt notice little to no diffrence w/ the MAF Plugged VS Unplugged. ------------------ 1992 Mustang 5.0 BBK cold air intake Dual Flows w/ H Pipe BBK Underdrive Pulleys BBK 65mm Throttle Body |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Go past redline????? | Jaegermeister2k | Modular Madness | 4 | 06-17-2003 09:27 PM |
| Motor breaking up past 3000 rpms. Gurus I need your help!!! | Miguel | Windsor Power | 0 | 08-13-2002 08:08 AM |
| Hydraulic Rollers past 7000rpms | ultraflo | Windsor Power | 4 | 03-26-2002 10:43 PM |
| Results from this past weekend at the track!! | Eric4Nitrous | Blue Oval Lounge | 16 | 03-02-2002 10:13 PM |
| Accidenly ran my car WAY past the redline today | tireburner163 | Blue Oval Lounge | 22 | 12-31-2001 11:26 PM |