Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-13-2005, 06:24 PM
|
#10 |
|
Registered Member
Join Date: Nov 1998
Location: Houston, Tx.
Posts: 3,887
|
Re: change rear end fluid?
The differential shop that I've used in the past recommends no gasket at all. Just black RTV around the flange and studs.
Also, Auburn Gear recommends against using synthetic oil with their limited slip units. They think the extra "slipperyness" of the synthetic oil with the friction modifier will make the unit slip too much and hence wear it out prematurely or maybe chatter around corners. I didn't want to void their warranty on my Auburn Pro unit, so I did use regular 75-90 wt. gear oil. Rev
__________________
'66 Coupe, 306, 350-375 HP, C-4, 13.07 e.t., 104.8 mph, 1/4 mi. O.B.C. #2 '66 coupe Last edited by Rev; 02-13-2005 at 06:42 PM.. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AOD getting bubbles in the fluid | Nixon1 | Windsor Power | 2 | 12-20-2003 11:36 AM |
| Yet another tranny fluid ?? | Simi Stang | Windsor Power | 4 | 09-30-2003 12:44 PM |
| Trans Fluid Change | HP400RW | Windsor Power | 1 | 03-17-2003 01:13 AM |
| Rear Polyurethane Bushings | TMASTER | Windsor Power | 4 | 11-06-2002 11:52 PM |
| T-45 Synthetic Fluid Change | aurilius_maximus | Modular Madness | 3 | 06-23-2001 06:15 PM |