Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-01-2005, 01:35 PM
|
#2 |
|
Registered Member
Join Date: Feb 2005
Posts: 3
|
Re: stock connecting rod question?
I would not reuse them. It could end up costing you more in the long run if one of those heads snap off. Those bolts are stretched after torqued and if you use them again, they will stretch more and more likely to yield (snap). Just my opinion.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stock Air Intake Box Question | ponyboy25 | Windsor Power | 4 | 02-14-2003 07:43 PM |
| AFR 165's or other heads with cam and stock induction | Mustang_GT_90 | Windsor Power | 27 | 11-25-2002 03:01 PM |
| What are 2001-2002 Cobras Running in the 1/4 Bone Stock? | '02 Cobra Guy | Modular Madness | 3 | 11-08-2001 01:23 AM |
| thermostat question | green94droptop | Windsor Power | 3 | 07-04-2001 02:11 AM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |