Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-01-2005, 06:52 PM
|
#11 |
|
Registered Member
Join Date: Jun 2000
Location: ventura,CA
Posts: 438
|
Re: stock connecting rod question?
Definately get the ARP bolts pressed in at your machine shop. They have to do a little bit of clearancing on the rod to get them to fit but it's worth it! One of weakest links in the small block ford is the puny stock rod bolts. The rod itself is pretty strong, but the bolts aren't. Make sure they aren't over-torqued either when you assemble them.
__________________
92 GT, 4:10 gears, centerforce clutch, 6# powerdyne blower, bbk h-pipe, flowmasters 65 Mustang 13.50 107mph 3000' ALt. 65 Falcon Straight Axle Drag Car |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stock Air Intake Box Question | ponyboy25 | Windsor Power | 4 | 02-14-2003 07:43 PM |
| AFR 165's or other heads with cam and stock induction | Mustang_GT_90 | Windsor Power | 27 | 11-25-2002 03:01 PM |
| What are 2001-2002 Cobras Running in the 1/4 Bone Stock? | '02 Cobra Guy | Modular Madness | 3 | 11-08-2001 01:23 AM |
| thermostat question | green94droptop | Windsor Power | 3 | 07-04-2001 02:11 AM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |