Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-12-2005, 06:26 AM
|
#9 |
|
Rat Killer
Join Date: Aug 2002
Location: Cold ass Ohio
Posts: 1,143
|
Re: poor dyno numbers from 408 :(
My Chuck Nuytten 850 actually flows around 920! Awesome carb. IF it actually came from Chuck (and some gearhead hasn't played with it since then) you should be good to go on that piece. Timing still might be an issue, but it's not gonna make the car way lean like that.
One mistake we've made in the past was swapping intakes. Went from a single plane (flat carb mount) back to a dual plane (slanted carb mount). What that did to us was made the rear float level WAY too low. Maybe check on that too. Get an answer from MSD yet? I think they even have the diagrams on there too, hold on I go looky for ya.
__________________
d-Con Racing "Nothing fancy, just 347 inches of RAT POISON!" MICE need not apply..... 
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| casting numbers | Sheldon | Built Ford Tough | 5 | 08-21-2002 05:58 PM |
| Powerdyne Dyno numbers and continuing frustration | 1995MGTS | Windsor Power | 17 | 03-31-2002 12:59 PM |
| How are these oil pressure numbers? | 88COBRA | Windsor Power | 3 | 02-26-2002 01:02 PM |
| Numbers from leakdown test | exgmguy | Windsor Power | 8 | 10-04-2001 08:32 PM |
| Intake Flow Numbers? anyone have them | NewAge 5.0 | Windsor Power | 0 | 09-25-2001 12:05 PM |