Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-30-2005, 06:55 AM
|
#8 |
|
Rat Killer
Join Date: Aug 2002
Location: Cold ass Ohio
Posts: 1,143
|
Re: Clutch and Tranny Oil
Treach, I'm with Andy. My clutch doesn't even start grabbing until about 3-4" off the floor. Like Andy said, only about 1" of play up top though. Sounds like your "tranny" problems are really clutch adjustment problems!
Make sure you tighten the jam nut on the adjuster so that it STAYS adjusted. IEC, think I'll go with the blue loctite so I don't have to heat up my tranny to change it. The blue should just run out of the drain, right? 
__________________
d-Con Racing "Nothing fancy, just 347 inches of RAT POISON!" MICE need not apply..... 
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Loud "pop" after clutch install, won't go into gear.. | Chris_H | Windsor Power | 3 | 08-11-2003 06:24 PM |
| Tranny Problem - Synchros, Clutch, or...? | JasonC302 | Windsor Power | 4 | 11-26-2002 10:44 PM |
| Clutch problem w/tremec tranny | coolguy620 | Windsor Power | 6 | 07-29-2002 03:50 PM |
| Got tranny in, how do i loosen new clutch? | Agent_4573 | Windsor Power | 1 | 05-31-2002 11:17 PM |
| Tranny update...Lentech VB | silver_pilate | Blue Oval Lounge | 10 | 05-02-2002 12:34 PM |