Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-12-2005, 08:56 PM
|
#11 |
|
Registered Member
Join Date: Jun 2002
Location: manassas, va
Posts: 186
|
Re: rollcage prices??
I just recommend getting it atleast pre-notched until you buy a notcher. Chrome moly is usally alot more expensive than mild steel. Remember no grinding on the welds or bars afterwards. Single pass on the welds. Check out wild rides.
__________________
1983 mustang, 393 cubic inch stroker small block, victor jr heads and intake, gold race 1.6 roller rockers. comp cam 304, 244@ .050. .576" hydralic retro roller cam,lunati rods. block was o-ringed,10:1 forged pistons, speed pro fit fit rings, clevite bearings,msd distributor and igniton,be cool huge radiator, black lite electric fan, march underdrive pulleys, mildon deep sump oil pan, mac 1 3.4" long tube headers, 3" dr gas x-pipe and mac exhaust,ARP bolts. car weighs 2900 lbs w/out driver, sub frames, weld wheels, mickey thompson sportsman pro 26 x 10.5 x 15's,#8 fuel line steel braided |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| gas prices | mustang145 | Built Ford Tough | 5 | 04-02-2001 05:38 PM |
| gas prices | mustang145 | Modular Madness | 2 | 03-09-2001 05:23 PM |
| gas prices | mustang145 | Blue Oval Lounge | 10 | 03-09-2001 04:20 PM |
| gas prices | mustang145 | Windsor Power | 4 | 03-09-2001 02:02 AM |
| gas prices | mustang145 | Small Ponies | 0 | 03-08-2001 11:32 PM |