where should i set my base time

bailey_57 · 07-01-2005, 10:48 AM

89 GT edelbrock performer rpm intake, 65mm tb, e-cam, ported e7's, 19lb inj adj. fuel pressure reg. i don't know if you need any more info than this i have it at 14degrees advanced right now. will that be good or do i need more or less. thanks.

Ian Gorman · 07-01-2005, 04:36 PM

I run 18 degrees with no problem. I would bump it up 2 degrees at a time until you feel less power etc then back it off by 2.

07-01-2005, 10:48 AM	#1
bailey_57 Registered Member Join Date: Mar 2000 Location: Berwick,Pa Posts: 127	where should i set my base time 89 GT edelbrock performer rpm intake, 65mm tb, e-cam, ported e7's, 19lb inj adj. fuel pressure reg. i don't know if you need any more info than this i have it at 14degrees advanced right now. will that be good or do i need more or less. thanks.

07-01-2005, 04:36 PM	#2
Ian Gorman Registered Member Join Date: Feb 2002 Location: Houston Posts: 5	Re: where should i set my base time I run 18 degrees with no problem. I would bump it up 2 degrees at a time until you feel less power etc then back it off by 2.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Back from the track....did worse than last time!!	82 GT	Windsor Power	18	05-12-2005 10:21 PM
Long Time No Post	OnMy3rdStang	Blue Oval Lounge	4	12-05-2004 10:34 PM
My report from racing at the NMRA event in Bowling Green (was ATTN: Lt. Dan)	andy669	Racer's Club House	12	10-08-2003 02:41 PM
Have not had race in a long time.	Five0	Stang Stories	2	12-23-2001 11:50 PM
Towed away this time! (Long)	1988GTCONERTIBLE	Windsor Power	6	10-26-2001 06:05 PM