Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-08-2005, 06:42 PM
|
#3 |
|
Registered Member
Join Date: Sep 2002
Location: cent.wis
Posts: 203
|
Re: Compression on motor question.....
The rings are irons. The bores were in very good shape, so said the dial bore gauge. So I just ran a rabbit turd hone through it and cleaned the walls really good with carb cleaner. Than oiled them. So I shouldn't be worried about it until I get some running time on it? When I went to start it the first time it wouldn't start because the rockers we too tight. than went over it again now she fires right up. But I was worried if maybe I bent a valve. But all seems OK. I hope.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| #1 @ TDC on compression stroke? | 302 LX Eric | Windsor Power | 1 | 09-23-2003 04:19 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Compression.... | cyberstang5.0 | Windsor Power | 1 | 03-22-2002 09:37 AM |
| Compression problem? | 96Saleen | Modular Madness | 1 | 10-22-2001 01:14 PM |
| high or low compression engines | Mustangboy89 | Windsor Power | 6 | 01-26-2001 03:04 PM |