Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-13-2005, 12:52 PM
|
#2 |
|
Registered Member
Join Date: Feb 2002
Location: Jacksonville, FL
Posts: 706
|
Re: rocker adjustment
To properly install the roller rockers, rotate the engine until the lifter is on the heel of the cam. While you're tightening the rocker, rotate the pushrod with your fingers. When you can't rotate it any further, the rocker is at zero lash. Then tighten the adjusting nut one-quarter to three-quarters turn. If you must turn the adjusting nut more than that, you must use shims to properly adjust the rockers.
__________________
1988 GT Convertible 331 10:1 TW heads, GT-40 intake, MSD, TRW flattops, B Cam w/ 1.7's, MAC exhaust, 24's, 70 TB, 76 MAF, 3.73's, Pro 5.0, Koni's, Anderson PMS, Wideband 02, yatta, yatta... One week with new motor, two speeding tickets...joy |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rocker adjustment | zach0 | Classic Mustangs | 3 | 04-24-2004 12:28 PM |
| Rocker arm re-adjustment | Prochrgd1 | Windsor Power | 1 | 04-14-2002 03:32 PM |
| Power loss due to bad RR adjustment? | gt93mustang | Windsor Power | 0 | 03-19-2001 01:17 PM |
| Rocker Arm Adjustment | bcinyuz | Windsor Power | 1 | 02-27-2001 02:05 AM |
| roller rocker adjustment | gray87GT | Windsor Power | 1 | 02-06-2001 01:14 PM |