Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-28-2005, 11:25 PM
|
#2 |
|
Ride Hard
Join Date: Oct 2000
Location: Wyoming IL
Posts: 1,094
|
Re: porting question
I would not want to use a drill due to it being bigger and hard to angle with. A cheap die grinder will work well with a good metal bit. If you are only doing the exhaust bumps and grinding them down smooth to match the rest of the port, you should run into no problems.
Ryan
__________________
65 Fastback 91 roller 306, H/C/I AOD-Bauman, PI Stallion, 4.10's and traction loc 04 Grand Cherokee Freedom Edition 79 Ford F-250 4x4 - Restored |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Another tire question | 96Saleen | Modular Madness | 6 | 02-10-2004 05:27 PM |
| question on porting | 93GTDIN | Windsor Power | 17 | 02-15-2003 07:05 AM |
| Home porting question | Agent_4573 | Windsor Power | 4 | 11-23-2002 07:01 AM |
| simple question | Lonzo | Classic Mustangs | 3 | 09-10-2002 09:37 AM |
| Trophy Stock Intake Question? | RL Wiltshire | Racer's Club House | 7 | 10-20-1999 08:11 PM |