Edelbrock aluminum heads

[ralph s]

mine work fine. but next time around im gonna do some port work and put the money somewhere else. if money isnt an issue and you want outta the box... by the time i got rockers i was @ 1500$

I love my Perf. RPM heads. I too have the 2.02/1.60 valves. I run a B-303 cam w/ 1.72 rockers & a Edel. Performer 5.0 manifold. The rest of my mods are in my sig. No I have not dynoed my motor. But my engine builder that assembled the shortblock was guessing some where around 320 horsepower, give or take. With that combination in my '90GT I was pulling mide to high 12s on motor & mid 11s on the juice. I've since sold my Performer manifold & am going to be getting the Performer RPM-2 in another month or so. I can't wait. I'd imagine I'll feel the improvement in the 'ol seat of the pants dyno. I built my motor a good 8 years ago though. If I could do it all over I'd have gone with AFR heads, a non alphabet cam & the RPM-2 intake. But I think the Edel. Perf. RPM heads are right up there near the top of the pack like nastyn8 stated. Are you going to do any portwork on them? What manifold are you going to run?