Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-20-2001, 09:07 AM
|
#5 |
|
Registered Member
Join Date: Dec 2000
Location: San Jose, California USA
Posts: 275
|
Well, I cleaned the one in front of the egr and my idle still sucks. I cleared the memory and drove for a while. Looked up the codes again and only got a 67 (clutch), but my car is still idleing like *** . Do you think it's the o2 sensors? Would I be getting a code for it if they were not working properly? When Im above 1100-1200rpm the car runs like it normally has.What can It be? What should I do?
------------------ 1993 Mustang GT - March Ram Air & Pullies, K&N, C&L 73mm MAF, Edelbrock 65mm TB & EGR, 3.73 Gears, 1 5/8in. Super Comp Hooker Equal Length Headers, 2 1/2in. High Flow H-Pipe & 2 1/2in. Flowmaster Cat Back, FlowTech Cut-Outs, Pro 5.0 Shifter, 16* Timing Advance, 8.5mm MSD Super Cunductor Plug Wires, Romoved front Sway Bar, Nitto DragRadial, Pro-Shift Lite, LX lights |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pulled codes...what do they mean? | Hethj7 | Windsor Power | 8 | 06-12-2003 12:03 PM |
| Pulled intake and swapped fuel rails now getting codes. | Rebel79 | Windsor Power | 3 | 09-03-2002 12:13 AM |
| pulled codes and could use some advice | Conman | Windsor Power | 9 | 08-17-2002 06:41 PM |
| Pulled codes today... | bobtodd | Windsor Power | 24 | 08-08-2002 07:55 PM |
| Ok, I pulled the codes, but what the heck do they mean | tireburner163 | Windsor Power | 18 | 12-02-2001 04:12 PM |