Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
11-08-2005, 10:42 PM
|
#1 |
|
Rat Killer
Join Date: Aug 2002
Location: Cold ass Ohio
Posts: 1,143
|
Re: wont go in gear
After ruling out obvious problems, adjust your cable according to the manufactureres specs, and you'll be fine.
__________________
d-Con Racing "Nothing fancy, just 347 inches of RAT POISON!" MICE need not apply..... 
|
|
|
|
11-09-2005, 01:56 PM
|
#2 |
|
Registered Member
Join Date: Jun 2000
Location: ventura,CA
Posts: 438
|
Re: wont go in gear
In my opinion, it could be the clutch cable. When metal heats up it expands. Maybe your clutch cable is expanding just enough to make it ineffective in disengaging the clutch.
Your clutch should be smooth and easy to press,like a honda  , even with that dual friction clutch. I have the same one on my stang. Aftermarket clutch quadrants make the pedal smooth. If the pedal is hard to push, something is up with your cable.
__________________
92 GT, 4:10 gears, centerforce clutch, 6# powerdyne blower, bbk h-pipe, flowmasters 65 Mustang 13.50 107mph 3000' ALt. 65 Falcon Straight Axle Drag Car |
|
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| raced a Supra Twin Turbo | Stang35th | Stang Stories | 63 | 08-23-2003 12:36 AM |
| The Right Speedo Gear... | Titan | Modular Madness | 8 | 09-23-2002 05:42 PM |
| speedo gear | redrider | Windsor Power | 1 | 01-17-2002 10:06 PM |
| new gear ratios | faststang90 | Windsor Power | 2 | 12-27-2001 03:29 AM |
| Trying to figure out what gear I have... | xspeed02 | Windsor Power | 7 | 03-31-2001 10:06 AM |