Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
09-25-2001, 11:11 AM
|
#1 |
|
Registered Member
Join Date: Sep 2001
Location: Franklin Park
Posts: 10
|
Use the AFR 165's,they flow more than enough out of the box to get your car into the 12's. The TrickFlow intakes use the same lower manifold,the upper plenums are the only difference.The Track Heat has a slight HP.advantage on the top end but gives up a little torque on the bottom end. Also with the intake/exhaust flow ratio of the AFR 165'
s I would recommend a single pattern camshaft for any N/A application.Go with the 24lb. injectors unless you are planing to go with a power adder soon then choose injectors according to HP. level. Have fun. [This message has been edited by 8950LX (edited 09-25-2001).] |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| more gasket questions, intake... | Coupe50h | Windsor Power | 3 | 03-05-2003 01:37 PM |
| head gasket replacement stuff questions | fiveohpatrol | Windsor Power | 4 | 04-13-2001 04:23 PM |
| Head ID and Extrude-honed Upper intake | RSE1805 | Windsor Power | 1 | 03-23-2001 05:03 PM |
| More head questions | Black-Sunshine | Classic Mustangs | 4 | 02-11-2001 08:45 PM |
| Head Gaskets, Header Gaskets, Intake Gaskets, etc | AxemanZZ | Windsor Power | 8 | 01-11-2001 01:09 PM |