Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-29-2005, 09:30 PM
|
#3 |
|
Registered Member
Join Date: Feb 2002
Location: Jacksonville, FL
Posts: 706
|
Re: Serious cut-out problem...
I re-torqued all of the intake manifold upper and lower bolts and checked for vacuum leaks. I also said to heck with it and replaced the tps, o2's, ECT and ACT. Fooling around I found the electrical harness to a thermactor relay completely corroded. No relation though. One of these days I'll rip all remaining smog crap out of the engine bay and really clean it up.
After all of that, it is runnning fine. Honestly, I think I wasted some money on those sensors and it was the GT-40 intake that just needed a re-torque. I haven't retorqued anything since my engine rebuild  but then, it's more fun just to drive the heck out of it!
__________________
1988 GT Convertible 331 10:1 TW heads, GT-40 intake, MSD, TRW flattops, B Cam w/ 1.7's, MAC exhaust, 24's, 70 TB, 76 MAF, 3.73's, Pro 5.0, Koni's, Anderson PMS, Wideband 02, yatta, yatta... One week with new motor, two speeding tickets...joy |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Serious timing problem...Help! | Dark_5.0 | Windsor Power | 8 | 02-09-2004 08:19 PM |
| Serious problem after gear swap....... | 1bad89lx | Windsor Power | 2 | 03-11-2003 01:00 AM |
| Please help stutering problem | Just me | Windsor Power | 10 | 10-18-2002 02:37 PM |
| Surging Problem - Help | Lawless | Windsor Power | 32 | 08-19-2001 10:57 PM |
| serious ignition problem? | g4life | Windsor Power | 2 | 02-17-2001 09:52 PM |