Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
12-04-2005, 09:14 PM
|
#1 |
|
Registered Member
Join Date: May 2005
Posts: 12
|
Re: How Do I Sense Voltage
right now the gauge is in the middle so i assume it is an amp meter not a volt meter because that would stay at the bottom til it senses voltage. This bad boy just sits in the middle i think the letters on either side are d and c. I need to know if i have what is needed or if there is a sensor i should buy then i think i can figure out how to get the wires to the gauge after that. IT IS A 1966 6 cyl chassis with a 289 out of a 68 ford fairlane. This is the reason my guages were not connected because i bought a muscle car when i was 18 and didn't know shit and as long as it roared i coulda cared less about the oil pressure gauge. Thanks for anything you can help with
|
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about sensors and voltage | MustangGT1990 | Windsor Power | 6 | 02-06-2003 02:55 PM |
| AMPS or Voltage? | Godslayer | Windsor Power | 4 | 08-02-2002 10:55 AM |
| Fuel pump voltage | greydan | Windsor Power | 3 | 01-26-2002 10:02 PM |
| PKRWUD or anyone with a DMM | PrplMonster | Windsor Power | 17 | 09-09-2001 05:42 PM |
| battery voltage and temp guage ?? | withamc | Windsor Power | 1 | 02-22-2001 04:52 AM |