Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-25-2001, 06:03 PM
|
#3 |
|
Registered Member
Join Date: Jul 1999
Location: INDIANAPOLIS
Posts: 404
|
They work good with open exhaust. A friend of mine did it with mufflers on. Didn't work to well. It ended up creating crankcase pressure ! Blew oil out all over the engine. He was running 3" tubes with flowmasters on a 66 mustang, running low tens. Basicly what we had figured out is that there is too much backpressure with mufflers on.
------------------ 302,vortech s trim @18-20lbs showing,edelbrock performer heads-o ringed,gt 40 upper&lower, mac 1 5/8"long tubes, sub frame connectors,50/50 rear, 70/30 front, manual rack,3:55 gears, c4 , best time 10.13@135mph |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 351W crankcase evacuation | jse9 | Windsor Power | 19 | 09-03-2004 12:00 AM |
| Header and Exhaust Installation | 1991GT | Windsor Power | 4 | 12-03-2002 11:17 PM |
| Whats the going price for long tube header installation? | Dark_5.0 | Modular Madness | 3 | 09-19-2002 03:29 PM |
| Header Gasket Help Needed | Phillip Long | Windsor Power | 5 | 05-03-2002 01:59 PM |
| Stage 8 header bolts? | Rev | Blue Oval Lounge | 8 | 01-13-2002 11:38 PM |