Summit 306 Kit ?????

silver_pilate · 01-27-2001, 10:06 PM

I agree; forged pistons are better for nitrous or boost.

That's not to say that hypereutectics won't hold up if set up right. Look what Lidio did with that stock 4.6 and a turbo....wasn't he in the 9's when the motor chunked? And wasn't it the rod that broke before the piston?

Hypereutectics are good because they are light weight and have less thermal expansion that forged pistons. Therfore you can run them to tighter tolerances. However, they can't take the same types of beatings that forged pistons can.

Bottom line...if you're going to go hyper, get a mechanic who has worked with the Keith Blacks before. Piston ring gap is critical when setting up hypereutectic pistons for different applications. If you set up the rings for N/A and run nitrous or a blower, you will blow the ring lands right off the pistons. Also, hypers do not hold up well to detonation. Make sure your car is in good tune so you don't pit the piston.

--nathan

------------------
--silver_pilate

'91 GT, Built 306, Wolverine 1087 cam, ported Windsor Jr. Irons, and all the goodies...click the link to the left to see a full list of my mods...

Tried and True 302 Being Built to Outrun You! heh heh heh...
--Texas Panhandle--
Check out my site

[This message has been edited by silver_pilate (edited 01-27-2001).]

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
summit discount code	90LxDroptop	Windsor Power	4	11-13-2002 03:56 PM
summit sold out?	zepherman	Blue Oval Lounge	7	09-10-2002 07:19 AM
Summit Racing mail-order blues	Pastor Robert	Small Ponies	4	06-23-2000 11:07 AM

01-27-2001, 10:06 PM	#4
silver_pilate DURKA DURKA!! Join Date: Sep 1997 Location: Lubbock, TX...(TX panhandle) Posts: 1,418	I agree; forged pistons are better for nitrous or boost. That's not to say that hypereutectics won't hold up if set up right. Look what Lidio did with that stock 4.6 and a turbo....wasn't he in the 9's when the motor chunked? And wasn't it the rod that broke before the piston? Hypereutectics are good because they are light weight and have less thermal expansion that forged pistons. Therfore you can run them to tighter tolerances. However, they can't take the same types of beatings that forged pistons can. Bottom line...if you're going to go hyper, get a mechanic who has worked with the Keith Blacks before. Piston ring gap is critical when setting up hypereutectic pistons for different applications. If you set up the rings for N/A and run nitrous or a blower, you will blow the ring lands right off the pistons. Also, hypers do not hold up well to detonation. Make sure your car is in good tune so you don't pit the piston. --nathan ------------------ --silver_pilate '91 GT, Built 306, Wolverine 1087 cam, ported Windsor Jr. Irons, and all the goodies...click the link to the left to see a full list of my mods... Tried and True 302 Being Built to Outrun You! heh heh heh... --Texas Panhandle-- Check out my site [This message has been edited by silver_pilate (edited 01-27-2001).]