Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-06-2006, 10:35 AM
|
#4 |
|
The Brit!
Join Date: Feb 2001
Location: Across the Pond!
Posts: 694
|
Re: 66 console
I say do the repairs and finish the rough repairs with a little wet sanding. The design isn't flawless to begin with so over smothing and sanding will only make it look like a nasty repo or overly processed by a heavy handed painter with too much Krylon at his/ her side. I would also put down a slightly 'rough' matt finish then recoat her with a low gloss or even a flat.
Worked wonders on mine. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1967 Floor Console help needed | jetfixer | Classic Mustangs | 1 | 04-04-2005 10:13 PM |
| Console Armrest Bolts | Southpaw | Windsor Power | 3 | 12-26-2001 09:56 AM |
| Console VS PC Games... | ed1371 | Blue Oval Lounge | 5 | 12-12-2001 09:29 PM |
| Radio install and Console??? 90 Notch | Chevyguy | Windsor Power | 6 | 03-09-2001 05:26 PM |
| will B&M fit 67 console? | make7UPYOURS | Classic Mustangs | 1 | 10-05-2000 06:15 PM |