Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-24-2006, 08:01 PM
|
#1 |
|
Registered Member
Join Date: Sep 1998
Location: Oviedo, FL
Posts: 992
|
Re: Preferred tranny pan gasket for C4
If it is split, it is tighten too much.
Make sure the pan rails are flat. Make sure that the bolt holes are dimpled in. If any of this is present. Flatten them. Then with a new gasket you shouldn't have any problem. Don't over tighten the pan either. Just snug, the pan bolts are only holding the tin trans pan on, not a connecting rod bearing.
__________________
"Support our Troops" Dave 1968 Cougar 2004 Thunderbird 2007 F150 Harley-Davidson, SuperCrew 1986 LTD 1997 Ranger 1992 Honda Civic |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| tranny swap? | 03stangGT | Modular Madness | 7 | 11-19-2006 08:57 AM |
| Yet another tranny fluid ?? | Simi Stang | Windsor Power | 4 | 09-30-2003 12:44 PM |
| 2002 valve cover gasket? | ponypower | Modular Madness | 1 | 07-26-2002 05:22 PM |
| Tranny update...Lentech VB | silver_pilate | Blue Oval Lounge | 10 | 05-02-2002 12:34 PM |
| This is bad! Did my Uncle cause my Racing tranny to overheat?(It's a long 1... sorry) | Stang_ROTY | Windsor Power | 1 | 08-30-2001 10:55 PM |